...the world's most energy friendly microcontrollers
2013-06-28 - EFM32G230FXX - d0005_Rev1.60
5
www.energymicro.com
2.1.11 Universal Synchronous/Asynchronous Receiver/Transmitter (US-
ART)
The Universal Synchronous Asynchronous serial Receiver and Transmitter (USART) is a very flexible
serial I/O module. It supports full duplex asynchronous UART communication as well as RS-485, SPI,
MicroWire and 3-wire. It can also interface with ISO7816 SmartCards, and IrDA devices.
2.1.12 Pre-Programmed Serial Bootloader
The bootloader presented in application note AN0003 is pre-programmed in the device at factory. Auto-
baud and destructive write are supported. The autobaud feature, interface and commands are described
further in the application note.
2.1.13 Low Energy Universal Asynchronous Receiver/Transmitter
(LEUART)
The unique LEUART
TM, the Low Energy UART, is a UART that allows two-way UART communication on
a strict power budget. Only a 32.768 kHz clock is needed to allow UART communication up to 9600 baud/
s. The LEUART includes all necessary hardware support to make asynchronous serial communication
possible with minimum of software intervention and energy consumption.
2.1.14 Timer/Counter (TIMER)
The 16-bit general purpose Timer has 3 compare/capture channels for input capture and compare/Pulse-
Width Modulation (PWM) output. TIMER0 also includes a Dead-Time Insertion module suitable for motor
control applications.
2.1.15 Real Time Counter (RTC)
The Real Time Counter (RTC) contains a 24-bit counter and is clocked either by a 32.768 kHz crystal
oscillator, or a 32.768 kHz RC oscillator. In addition to energy modes EM0 and EM1, the RTC is also
available in EM2. This makes it ideal for keeping track of time since the RTC is enabled in EM2 where
most of the device is powered down.
2.1.16 Low Energy Timer (LETIMER)
The unique LETIMER
TM, the Low Energy Timer, is a 16-bit timer that is available in energy mode EM2
in addition to EM1 and EM0. Because of this, it can be used for timing and output generation when most
of the device is powered down, allowing simple tasks to be performed while the power consumption of
the system is kept at an absolute minimum. The LETIMER can be used to output a variety of waveforms
with minimal software intervention. It is also connected to the Real Time Counter (RTC), and can be
configured to start counting on compare matches from the RTC.
2.1.17 Pulse Counter (PCNT)
The Pulse Counter (PCNT) can be used for counting pulses on a single input or to decode quadrature
encoded inputs. It runs off either the internal LFACLK or the PCNTn_S0IN pin as external clock source.
The module may operate in energy mode EM0 – EM3.
2.1.18 Analog Comparator (ACMP)
The Analog Comparator is used to compare the voltage of two analog inputs, with a digital output indi-
cating which input voltage is higher. Inputs can either be one of the selectable internal references or from
external pins. Response time and thereby also the current consumption can be configured by altering
the current supply to the comparator.
相关PDF资料
EFM32G232F64 IC MCU 32BIT 64KB FLASH LQFP64
EFM32G280F64 MCU 32BIT 64KB FLASH 100-LQFP
EFM32G290F64 MCU 32BIT 64KB FLASH 112-BGA
EFM32G840F64 MCU 32BIT 64KB FLASH 64-QFN
EFM32G842F64 IC MCU 32BIT 64KB FLASH LQFP64
EFM32G880F128 IC MCU 32BIT 128KB FLASH 100QFP
EFM32G890F64 MCU 32BIT 64KB FLASH 112-BGA
EFM32GG230F512 IC MCU 32BIT 512KB FLASH 64QFN
相关代理商/技术参数
EFM32G230F128G-E-QFN64R 功能描述:128K FLASH, 16K RAM, AES 制造商:silicon labs 系列:Gecko 包装:剪切带(CT) 零件状态:在售 核心处理器:ARM? Cortex?-M3 核心尺寸:32-位 速度:32MHz 连接性:I2C,IrDA,智能卡,SPI,UART/USART 外设:欠压检测/复位,DMA,POR,PWM,WDT I/O 数:56 程序存储容量:128KB(128K x 8) 程序存储器类型:闪存 EEPROM 容量:- RAM 容量:16K x 8 电压 - 电源(Vcc/Vdd):1.98 V ~ 3.8 V 数据转换器:A/D 8x12b,D/A 2x12b 振荡器类型:内部 工作温度:-40°C ~ 85°C(TA) 封装/外壳:64-VFQFN 裸露焊盘 供应商器件封装:64-QFN(9x9) 标准包装:1
EFM32G230F128-QFN64 制造商:Energy Micro AS 功能描述:MCU, 128K FLASH, USART+UART 3, QFN64 - Tape and Reel 制造商:Energy Micro AS 功能描述:MCU, 128K FLASH, USART+UART 3, QFN64 - Cut TR (SOS) 制造商:Energy Micro 功能描述:energy micro EFM32G230F128-QFN64 Microcontrollers (MCU) 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 128KB FLASH 64QFN
EFM32G230F128-QFN64T 制造商:Energy Micro AS 功能描述:MCU, 128K FLASH, USART+UART 3, QFN64 - Trays
EFM32G230F128-QFN64-T 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 128KB FLASH 64QFN
EFM32-G230F128-SK 功能描述:IC MICRO KIT GECKO 64QFN RoHS:是 类别:套件 >> 半导体产品 - IC 元件分类 系列:Gecko 其它有关文件:NXPLOGIC2-KIT-ND Contents 标准包装:1 系列:74AUP 套件类型:逻辑 值:180 件 - 18 种值各 10 件 包装:- 安装类型:表面贴装 包括封装:6-XSON,8-XSON,8-XQFN 产品目录页面:2653 (CN2011-ZH PDF) 工具箱内容:(10) 568-4391-1-ND - IC GATE MULT-FUNC CONFIG 6-XSON(10) 568-4390-1-ND - IC CONFIG MULT-FUNC GATE 6-XSON(10) 568-4389-1-ND - IC GATE DUAL FUNCTION 8-XSON(10) 568-4388-1-ND - IC GATE DUAL FUNCTION 8-XQFN(10) 568-4387-1-ND - IC F-F D-TYPE POS EDGE 8-XSON(10) 568-4386-1-ND - IC F-F D-TYPE POS EDGE 8-XQFN(10) 568-4385-1-ND - IC CONFIG MULTI-FUNC GATE 6-XSON(10) 568-4384-1-ND - IC EX-OR GATE 3-IN 6-XSON(10) 568-4383-1-ND - IC F-F D-TYPE POS EDGE 6-XSON(10) 568-4382-1-ND - IC LATCH D-TYPE 6-XSON更多... 其它名称:NXPLOGIC2-KIT
EFM32G230F128-T 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 128KB FLASH 64QFN
EFM32G230F32 功能描述:ARM微控制器 - MCU 32KB FLASH 8KB RAM 32MHZ 1.8-3.8V RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT
EFM32G230F32-QFN64 制造商:Energy Micro AS 功能描述:MCU, 32K FLASH, USART+UART 3, QFN64 - Tape and Reel 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 32KB FLASH 64QFN